Saunagen PH-I Manuel d'instructions

Instruction Manual Thank you for choosing the SaunaGen® Infrared Sauna! www.saunagen.com

21. Take down the bag of screws affixed to the CD box; use a cross screwdriver to screw in the CD Box over the CD player. See FIG-24, 24.1

Operation 1. Precautions a. Check all the circuitry and the plug meet all requirements. b. Set the temperature and time to a comfortable level, nor

Warnings 1. Safety precautions a. To avoid fire, do not dry clothes or leave any towels in the sauna. b. To prevent burns or electric shocks, do

Some problems with heater See the 3rd section of heater problemSenor wire is not functioning Re-connect or replace the senor wire 4 Malfunctioning o

Maintenance Cleaning Clean the faceplate with a wet towel, or clean with a small amount of hand-soap mixed with warm water if necessary. Clean the

SaunaGen® Infrared Sauna Warranty Five-year limited warranty on electrical, heater and cabinetry. One-year limited warranty on stereo. THIS UNIT IS

Please register your SaunaGen® product to receive a full warranty. Please fill out the following information and mail the form to the following ad

Index ===================================== Introduction, benefits, highlights……………………………………………………...2 Installation requirements…………………………………………

1. Introduction SaunaGen welcomes you to the most affordable infrared sauna in the nation! We also congratulate you on your new path to

Installation procedure Sauna Room: 1. Structure of Infrared Sauna. See FIG-1 2. One unit packed into two cartons. See FIG-2 FIG-2

3. Place the bottom board in the desired location of your sauna, and make sure which side is the front and which side is the back. See FIG-3.

7. Align the right side board with bottom board’s corresponding battens, make sure right side board fits flush into right back-side board. Latch it.

FIG-11 Connecting wire FIG-12 Assembling sitting board 12. Put the sitting board horizontally on c

15. Take out the car stereo with CD player, check its spare parts, put the stereo into the CD frame. Then screw the attached stereo support to the ste

connecting with the controller on the internal top board. See FIG-17 19. All the infrared heaters are pre-assembled. See FIG-18. Connect all the wires